Title: 350/350R-01: Code Requirements for Environmental Engineering Concrete Structures and Commentary
Publication: Technical Documents
Appears on pages(s): 387
Keywords: Chemical attack; coatings; concrete durability; concrete finishing (fresh concrete); concrete slabs, crack width, and spacing; cracking (fracturing); environmental engineering; inspection; joints (junctions); joint sealers; liquid; patching; permeability
Note: 350/350R-01 is available in PDF format only. However, a newer version of this document exists. This document was replaced by 350-06.
The code portion of this document covers the structural design, materials selection, and construction of environmental engineering concrete structures. Such structures are used for conveying, storing, or treating liquid, wastewater, or other materials, such as solid waste. They include ancillary structures for dams, spillways, and channels. They are subject to uniquely different loadings, more severe exposure conditions and more restrictive serviceability requirements than normal building structures. Loadings include normal dead and live loads and vibrating equipment or hydrodynamic forces. Exposures include concentrated chemicals, alternate wetting and drying, and freezing and thawing of saturated concrete. Serviceability requirements include liquid-tightness or gas-tightness. Typical structures include conveyance, storage, and treatment structures. Proper design, materials, and construction of environmental engineering concrete structures are required to produce serviceable concrete that is dense, durable, nearly impermeable, resistant to chemicals, with limited deflections and cracking. Leakage must be controlled to minimize contamination of ground water or the environment, to minimize loss of product or infiltration, and to promote durability. This code presents new material as well as modified portions of the ACI 318-95 Building Code that are applicable to environmental engineering concrete structures. Because ACI 350-01 is written as a legal document, it may be adopted by reference in a general building code or in regulations governing the design and construction of environmental engineering concrete structures. Thus it cannot present background details or suggestions for carrying out its requirements or intent. It is the function of the commentary to fill this need. The commentary discusses some of the considerations of the committee in developing the ACI 350 Code, and its relationship with ACI 318. Emphasis is given to the explanation of provisions that may be unfamiliar to some code users. References to much of the research data referred to in preparing the code are given for those who wish to study certain requirements in greater detail. The chapter and section numbering of the code are followed throughout the commentary. Among the subjects covered are: permits, drawings and specifications, inspections, materials, concrete quality, mixing and placing, forming, embedded pipes, construction joints, reinforcement details, analysis and design, strength and serviceability, flexural and axial loads, shear and torsion, development of reinforcement, slab systems, walls, footings, precast concrete, prestressed concrete, shell structures, folded plate members, provisions for seismic design, and an alternate design method in Appendix A. The quality and testing of materials used in the construction are covered by reference to the appropriate standard specifications. Welding of reinforcement is covered by reference to the appropriate AWS standard. Criteria for liquid-tightness testing may be found in 350.1 and 350.1R.