Title:
Tensile Capacity of Single Anchors in Concrete: Evaluation
of Existing Formulas on an LRFD Basis
Author(s):
C. Ben Farrow, lmed Frigui, and Richard E. Klingner
Publication:
Structural Journal
Volume:
93
Issue:
1
Appears on pages(s):
128-137
Keywords:
anchor bolts; anchors (fasteners); safety; structural design.
DOI:
10.14359/9683
Date:
1/1/1996
Abstract:
This study concerns the prediction of tensile capacity as governed by con-crete cone failure of single anchors placed in untracked, unreinforced con-crete and located far from a free edge and far from other anchors. A total of approximately 801 data points is available from tests on such anchors. A total of 31 data points consisting of data on high-strength anchors previously compiled by Klingner et al., ’ Collins et a1.,2 and Cannon is accessible from tests on single anchors failing by fracture of anchor steel. Using common definitions and nomenclature for all variables and material properties, each data set is placed in a database using SI units and concrete cube strengths. The concrete cone failure data are then plotted against capacities predicted by three existing methods: 1) the 45 deg cone method of ACI 349-90, Appendix B; 2) a variable angle cone method (VAC); and 3) the concrete capacity method (CC method). Observed data are compared against these existing methods in terms of average square error and load and resistance factor design (LRFD). Finally, using theprinciples of load and resistance factor design (LRFD) and following the design procedure of AU 349-90, Appendix B, the probability of steel or concrete failure under known loads and the probability of concrete failure under unlimited loads are calculated. Based on those comparisons, each approach is evaluated with respect to accuracy and suitability for use in design. For single tension anchors with embedment depths less than 8 in., all three capacity prediction methods fit most of the data relatively well. However; the CC method is more accurate and has a distinctly lower probability offailure when the embedment depth is greater than 8 in.