Frequently Asked Questions

In This Section

Other Sources for Answers

Search other resources on the ACI website for answers to technical questions

Technical Questions

ACI Committees, Membership, and Staff have answered common questions on a variety of concrete related topics.



Found 42 FAQs.

Question: Curing and curling of concrete slabs over vapor retarders

Question: Increasing the load capacity of a slab-on-ground using an overlay

Question: Tolerances for concrete slabs supporting steel tanks

Question: Slabs-on-ground

Question: When should saw cuts be made on a concrete slab?

Question: Two-way slabs design, ACI 318 vs. FEM

Question: Consolidation of concrete—required or not?

Question: Placement of welded wire reinforcement (WWR) in a slab-on-ground

Question: Cleaning slabs during tilt-up construction

Question: Determining the cause of a crack

Question: Curing Cylinders for Acceptance Testing

Question: Tolerances for floors supporting operable partitions

Question: Vapor barriers

Question: Design of Slabs-on-ground

Question: Acceptable concrete cracking

Question: Air tests for non-air-entrained concrete

Question: What nominal maximum sizes of aggregate are recommended?

Question: Painting the floor

Question: Shear Design Provisions in ACI 318-19

Question: What are shrinkage-compensating expansive cement and concrete?

Question: Curling, shrinkage, and w/cm

Question: Difference between a contraction joint, isolation joint, expansion joint, construction joint, an...

Question: Governing version of ACI 318

Question: Substantial structural damage

Question: Decorative concrete finishes

Question: Minimum concrete cover for balconies with PT cables

Question: Where is fiber-reinforced concrete mostly used in practice?

Question: What is the minimum fiber dosage? Is it possible to use less than the minimum dosage?

Question: Heat of hydration and the importance of controlling it

Question: Strength of concrete

Question: The effect of joints on the durability of concrete structures

Question: The importance of proper drainage

Question: Improving the abrasion resistance of concrete

Question: What is the purpose of finishing and texturing concrete surfaces?

Question: When can the finishing procedure be started?

Question: What is curing?

Question: How is the abrasion resistance of concrete determined?

Question: How is the shrinkage of concrete determined?

Question: Popouts or popoffs?

Question: What are the primary benefits of using fiber-reinforced concrete compared to traditionally reinf...

Question: How is reinforced concrete designed using fibers instead of traditional steel?

Question: What is minimum reinforcement for crack-width control and how is design accomplished using fiber?